AC110-240V Automatic Sensor Light Switch LED PIR Infrared Motion Sensor Detection Mini LED Sensitive Night Light Indoor Outdoor

Type 1 AC110-240V is described as follows:

Product parameters

Product function: When a person enters the induction range, the power is immediately switched on and switched off according to the set time after the person leaves. This achieves the goal of intelligent energy-saving control. It is compatible with all electrical devices such as LED lamps, energy-saving lamps, fluorescent lamps, incandescent lamps, alarms, exhaust fans, etc.

1. Operating voltage: Universal voltage range AC110-240V and universal voltage DC9-24V are optional (don't worry about voltage instability)

2. Rated load current: 10A (The rated AC voltage allows control of 1200W incandescent lamps, LEDs, energy-saving lamps and other 300W electrical appliances, 120W DC voltage)

3. Induction distance: adjustable to less than 8 meters in diameter;

4. Detection angle: 360-degree depression angle, 140-degree cutting angle;

5. Delay setting range: 5 seconds to 10 minutes (Note: the delay refers to the time the power is cut off after the person leaves, not the time it takes to detect the person's arrival; everything is detected immediately)

6. Power consumption: <0.05W

220V Type 2 described as follows:

Product parameters

1. Detection mode: PIR induction + light control

2. Rated voltage: 220V 50HZ

3. Output mode: thyristor

4. Charging power:

100W incandescent lamp

30W energy-saving light bulb

18W LED

5. Delay: 20s (when people move within the detection range, the switch will automatically delay and remain connected; if people remain inactive, the switch will stop responding)

6. Detection distance: 3-6M (high temperature will affect the switch's sensitivity)

7. Detection angle: 110°

Characteristic:

1. Adaptive filament, energy-saving light bulb

2. This lamp is equipped with a body sensor. If the light is switched on, and the person leaves, the bulb will switch off.

3. The automatic internal body sensor adopts an infrared heat dissipation device; it can accurately capture the low-frequency signal of movement and automatically turn on

4. When the person leaves, the light switches off automatically, which is convenient and energy-saving.

The 5. Inside the tower, an automatic ambient light detection circuit has been installed. Only when the ambient light exceeds a set value will the sensor receive the signal and switch off the lamp. This saves energy.

Notice:

1. During installation, please unplug the power supply to ensure a safe electrical connection.

2. Do not apply it to an overwhelming current or voltage.

3. Do not install in a way that would allow access to the waterway.

4. The detection distance will change depending on the temperature difference. In summer, the detection distance will be short (obviously, when it is close to human body temperature); in winter, the detection distance will be greater.

5. Do not install below -20 or above 60

6. Do not expose to sunlight

Do not follow the installation; there are moving objects inside.

8. When first powered on, there will be a 1-minute startup time; during this time, the device will turn on, which is normal.

9. In coastal areas, the thermal airflow will trigger the sensor due to the ocean current. If the incandescent lamp emits a lot of heat, please keep it away from the sensor (at least 1 meter).